Doming is a process where you dispense 2 part polyurethane resin onto a vinyl graphic to create a “domed” effect. The doming fluid will migrate to the edge of the cut graphic, but due to the surface tension of the vinyl, will resist flowing over the edge. Curing occurs within 12 to 24 hours. The result is an attractive clear coat with three dimensional properties. Each cartridge holds 75ml of resin, and covers approximately 80 square inches. The polyurethane resin is UV stable, outdoor durable, non-yellowing, and semi flexible. Our new formulation is slightly thinner and dries slower. The upside is that it has less tendency to form bubbles, and has a shelf life up to 18 months.
Fuel for the torch cannot be shipped and is not included.
2 - 75ml ProDome Resin Cartridges
4 - ProDome Green Mixers
1 - ProDome Applicator Gun
1 - Bubble Remover Torch
Out of Stock. Please check back again soon..
Fuel for the torch cannot be shipped and is not included.
10 - 75ml ProDome Resin Cartridges
20 - ProDome Green Mixers
10 - Fine Point Tips
1 - ProDome Applicator Gun
1 - Bubble Remover Torch
Out of Stock. Please check back again soon..
One 75ml cartridge of two part polyurethane resin. Covers approximately 80 square inches.
Mixers go in the end of the cartridge to fully mix the two component polyurethane components together prior to dispensing.
These fine point tips fit on the end of the mixer for fine control for small doming applications.
Provides a quick torch flame to pop bubbles when doming product is still wet. The lighter fluid fuel is not included.
Prepare application gun. Be sure the plunger is fully retracted. Open clip in front of gun.
Remove one ProDome cartridge from package. Slide the cartridge through the front clip. Close the clip
by pulling the cartridge up until it clicks.
Close the clip by pulling the cartridge up until it clicks.
Remove the cartridge cap by twisting 90 degrees anti-clockwise and pull to separate. Also, the rubber seal may stick to cartridge under the cap, remove seal, pull off slowly. Attach mixer to cartridge by twisting the mixer into the grooves on the cartridge 90 degrees clockwise.
Purge about 3ml-5ml of the resin to make sure it’s mixed well. Make sure there are no bubbles. Apply resin to vinyl at a slow comfortable rate. Applying Acudome Fast will cause it to not mix correctly!
After 2-3 minutes the resin should flow to the outside edge of your graphic, if not add a couple more drops of resin. If resin still has not flowed to corners you can use your repair tool to push resin slowly to the edge.
After leaving the decal for 5 minutes, if there are any bubbles a quick flash with the bubble remover should remove them. Do not leave flame on. Just a quick flash. If bubbles do not come out place repair tool into resin and move around to bring bubble to top surface. Then do another quick flash with the bubble remover. If resin has run off decal. Let resin set for 5-6 minutes. Then with repair tool scrape alongside of decal scraping resin away from decal. The resin will reseal itself. It takes 12 hours to touch, 48 hours to ship putting wax paper between them and if you are applying decals to car, truck or boat let it cure for at least 6 days before applying.
ProDome Application